Hey
First in the USA high schools a vaulter has to use poles over their weight… i agree with this totally .. (the only exception is when the schools head coach, who is a sprint coach, buys one pole, a 15 foot 190, so all his pole vaulters can use it.... holding 12 feet on this polke makes it a telphone pole for even a 190 pound vaulter)
Second I feel it's best to hold 12 to 6 inches from the top of a pole, or to the band in America by rule...( on poles that are made with symmetrical patterns)…
Rule one. The grip height on any pole should be so that you can "peak" your vault with the standards at, minimum!! 20"(50cm) to 24"(60cm)….
Rule two. If the pole bends very little and you penetrate "deep'.. start raising your grip.
Rule three. If the pole bends very little and you do not penetrate… lower your grip OR go to a smaller/shorter pole if it is not under your weight.
Rule four. If the pole bends big! AND you penetrate deep… go to a bigger pole with the same grip.
Rule five. If the pole bends very big! AND you do not penetrate!!! (landing on the front pad or the ground, or on you’re a$$ or head) MOVE YOUR GRIP DOWN!!!!!
Rule six. Follow rules one through five…………..
quick pole progression question
by Hickman » Tue Mar 29, 2011 12:19 am
if you're using 11-6 120lbs, clearing 10-6 in getting deep penetration and the pit. Is a better pole progression at 11-6 130 lbs, or a 12 130lbs? also is it true that the flex rating for 12 130 is the same as 11-6 120
A 10-6 vault, based on the Six Step "MID" Chart, needs an average grip of 11-5…
If you are gripping a little lower than that, you are vaulting reasonably efficient.
The short answer is a longer pole……..
A longer answer is: To jump 11-6 you need a grip of 12 feet, on average. So I would get a pole (based on weight and manufacture band position) that you can potentially grip 12 feet…
You can check pole and grip issues by referring to the "MID" chart in the future… the grip to jump height averages where documented going all the way back to steel vaulting and have held "true" for 40 years… steel or fiberglass....
dj